What’s New

The aim of the WEST project is to turn the Tore Supra tokamak (France) into a test bed for ITER, with an actively cooled ITER-like tungstendivertor.

Component installation is underway. The latest WEST Newsletter (#11) reports on the most recent milestone: the installation of the divertor coil casings. Two stainless steel rings constituting the housing for the conductor windings are now assembled and positioned inside the vacuum vessel at their nominal position. The building of the coil winding can now begin.

(Photo Christophe Roux CEA-IRFM)

Read all the latest from WEST in Newsletter 11 here.

An 18-month development program to prototype remote handling tooling for the ITER fusion device was demonstrated on 26 and 27 October as part of collaboration between the European Domestic Agency for ITER and the Culham Centre for Fusion Energy (CCFE) in the UK.

Representatives from the ITER Organization, the European agency, Assystem UK, and AMEC Foster Wheeler were at Culham to see a fully remote deployment of prototype remote pipe cutting and welding tooling developed by Culham's RACE (Remote Applications in Challenging Environments).

Under a grant from the European Domestic Agency, RACE and CCFE's Engineering Implementation Department have produced a set of prototype tools intended for eventual use maintaining the neutral beam heating systems at ITER. Up to now, remote cutting and welding of process piping to the required codes, and under the challenging conditions of the ITER tokamak, had not been demonstrated, and is one of the higher risk areas across the ITER remote maintenance strategy.

ITER will rely on remote handling for maintenance operations where space and/or environmental conditions in the machine do not allow manual intervention. Interconnected components, pipes, cranes and tooling will all need to be routinely repaired and maintained with millimetric accuracy.

Read the full reports of the event on the European Domestic Agency and CCFE websites.